Underbody Lifting Equipment
Underbody lifting equipment allows safe and easy changeout of underbody components for maintenance and replacement.
Lifting Bogie Platform
Lifting Bogie Platform: Emanuel Lifting Equipment
The CSF is a lifting bogie platform which runs on rails and allows for the handling, removal, and assembly of railway bogies during maintenance. The upper pad has a central opening which allows the operators to work safely under the lifted railway carriage.
The carriages support plane is made in compliance with the different track gauge systems – starting from a minimum of 1000 mm and up to a maximum of 1676 mm.
The lifting system can be controlled either through three-phase power supply or via a battery pack installed on the machine. In event of failure, a manual pump is installed to enable platform lifting and lowering.
Specifications
Manufactured by:
Roll Over Stand
Roll Over Stand: INNDES Lifting Equipment
Rollover Stand is a handling equipment specially used for diesel engines maintenance, where it is needed to rotate item in different positions during installation or dismounting activities.
It can be also used for different components within its capacity of 3 or 6 tons.
The equipment is made of independent groups that can be assembled in different distances to have the required free length to fit the component. Very easy to install without special foundation.
Different models are available according to different capacity and length between the rotating wheels.
It’s designed for the highest safety level during rotation and stop in any position.
Specifications
Manufactured by:
Dummy Bogies
Dummy Bogies: Emanuel Lifting Equipment
The CS is temporary railway bogie which runs on rails supporting rolling stock during bogie refurbishment.
Temporary bogies are also used for moving rolling stock during manufacturing processes, long term maintenance periods, as auxiliary elements in depots and track construction.
The carriages support plane is made in compliance with the different track gauge systems: starting from a minimum of 1000, 1435 mm and up to a maximum of 1676 mm.
Specifications
Manufactured by:
Underbody Mount and Dismount Equipment
Underbody Mount and Dismount Equipment : INNDES Lifting Equipment
The use of Underbody Mounting and Dismounting Equipment significantly improves operator efficiency and safety.
Through installing inside an elevated track, the rolling stock is free to run without any obstruction and the platform is always available for use.
The plane moves perfectly parallel with the track even with an offset load.
Steps for use:
1. Position close to the component to be disassembled/assembled.
2. Lift the plane to support/fasten the component.
3. Lower to unloading the component or to release.
4. Slide the component to evacuate or put out the platform on track.
Features:
Battery powered for easy installation and access.
Capable of handling loads up to 12 kN
Local support available
Specifications
Manufactured by:
